Chamberlain garage door close halfway help!
This morning my dad drove the car halfway out of garage and pressed the
remote so the garage door wont close anymore, it stops halfway and the
light inside blinks. after l hold the bbutton to force closed the
door, l seeone sensor on cornor is green, the other turned yellow.
/>help!
Did the door actually hit the car & maybe bent something on the
door so it now is binding up. Work the door by hand (released from opener)
to see ifit will open & close easily.
The sensors have always been green & yellow, which is normal. There is
only one LED on them & therefore they don't have the ability to change
colors.
Both sensors will show green if they're aligned properly, so
check that first. Also make sure there are no cobwebs, dust, etc.
covering the lenses.
Maybe your sensors were knocked out of alignment or there is an
obstruction. If you know your model number (or you can look it up) go to:
http://chamberlain-diy.com/doityourself/support/manuals
5 posts
• Page 1 of 1
garage door opener malfunction Light's on the garage door opener have stopped working Garage door won't open or close with the transmitters. Garage door problems...help - opens and closes inconsistently My power garage door is not closing all the way.Within 18 in. of closing it stops, then reverses?Any DIY tips? my garage door opener remotes do not work in very hot weather How much electricity is used each time I open and close my Genie chain glide garage door opener? Has anyone actually beaten the garage door before it closes How do you fix an automatic garage door? Garage door not closing all the way HELP!! How to re-align sensors from garage door? Garage Door Opener - Noisy on Closing Our garage door will close, but will only open a foot then stop - what's wrong I have a linear garage door opener that wont close by itself unless you use the manual button, HELP! Who is onlineUsers browsing this forum: 4 guests |